A brief description of the RMI was given earlier in this handbook on page 52. This section covers RMI procedures as they relate to tracking a course and intercepting a course. The procedures given are similar to those previously described on pages 136 through 138 using the CDI. In the RMI illustrations, only the double-barred bearing pointer is displayed.
 Tracking a Course. Follow these steps (Fig. 8-16) when tracking inbound. A similar procedure is used when tracking outbound.

  1. Your heading is 360°, you are on the 360° course (inbound on the 180° radial), and the bearing pointer indicates 360°.
  2. As you maintain a constant heading of 360°, the bearing pointer indicates you have drifted off course approximately 10° to the right. This indicates a left crosswind component.
  3. Turn left 20° to a heading of 340°.
  4. The aircraft has returned to course and the bearing pointer again indicates 360°. If you maintain the present heading of 340° you will fly through the course. If you return to the original heading of 360°, you will drift off course to the right again.
  5. Reduce the drift correction to 10° left. The aircraft heading is now 350°. This correction may hold the desired course, or it may be too small or too large. If the course is not maintained, further bracketing will be required.

 Intercepting an Inbound Course. Follow these steps (Fig. 8-17) when intercepting an inbound course. A similar procedure is used when intercepting an outbound course. The first three steps may be omitted if you turn directly to the interception heading.

  1. Determine the inbound course to be intercepted, then turn to a heading that parallels it. In this example, the 360° course is to be intercepted.
  2. After paralleling the inbound course, note the deflection of the bearing pointer. In this example, the deflection is 30° left.

Figure 8-16. VOR tracking with RMI.

Figure 8-17. VOR course interception with RMI.

  3. Double the number of degrees deflection to determine the interception angle. The angle should not be less than 20° nor greater than 90°. Turn to the interception heading. In this example, it is 300°.
  4. Hold the interception heading until the bearing pointer indicates the desired course, 360°. At this point you have intercepted the course.
  5. Turn to the desired course (this turn should be started before reaching the course unless the rate of interception is very slow).
 
 

FAATest.com - Aviation Library Dauntless Software hosts and maintains this library as a service to pilots and aspiring pilots worldwide. Click here for ways to show your appreciation for this service. While much of this material comes from the FAA, parts of it are (c) Dauntless Software, all rights reserved. Webmasters: please do not link directly to individual books in this library--rather, please link to our main web page at www.dauntless-soft.com or www.faatest.com. Thanks!